2. Place plastic over the hole
3. Close the tank again. This prevents fluid from leaking out when the brake system is opened.
4. Remove the bolt from the brake drum and remove the drum.
5. Disconnect the brake hose and parking brake cable from the back of the brake shield.
6. Loosen the bolts and remove the brake shield and lock plate.
Article posted on a web portal (OpelBook.ru)
7. Remove the axle shaft together with the brake shield from the axle.
9. The installation of the axle shaft is performed in the reverse order of removal.
10. On the back side of the brake shield there is a seal that needs to be lubricated.
11. Tighten the mounting bolts evenly to a torque of 95 Nm.
12. Install other removed parts as directed.
13. Bleed the brake system.
Disc brakes
1. Remove the caliper from the guide, washer, brake pads.
2. Disconnect the parking brake cable as described in Chapter Cardan shafts, main gear.
3. The following work is carried out in accordance with the illustration.
4. Loosen the bolt (1) and remove the ABS yaw rate sensor.
5. After this, unscrew the four nuts (2) and remove the axle shaft together with the bearing housing and brake shield from the axle sleeve.
6. Be careful not to damage the seal inside the bridge sleeve. The seal is shown in the illustration. 6.2.
7. Thoroughly clean the mating surfaces of the bridge sleeve and bearing housing.
The installation of the axle shaft is performed as follows:
1. Insert the axle shaft with the bearing housing and brake shield into the axle sleeve.
2. The mating surface of the sleeve or bearing housing is lubricated with a sealant.
3. Screw on the four nuts (2) shown in the illustration with washers.
4. Tighten evenly to 75 Nm.
5. Other work is performed in the reverse order of removal.
6. Details of the installation of brake components are described in Chapter Cardan shafts, main gear.
Visitor comments