Clutch pedal — removal and installation (Opel Omega A)

1. Disconnect the clutch cable from the pedal as described in Chapter 3.

2. From inside the vehicle, disconnect the electrical wiring from the brake light switch, disconnect the brake pedal return spring, and disconnect the servo motor push rod from the brake pedal.

3. Loosen the nut at the end of the pedal arm. Disconnect the clutch pedal return spring.

4. Remove the nuts securing the pedal hanger to the bulkhead, and rotate the hanger around the steering column to allow the pedal arm to be removed. Note that on later models it may be necessary to remove the steering column to allow the pedal hanger to clear the mounting posts. The column can be removed as described in Section 10, Chapter 22, noting that there is no need to remove the steering wheel or lock cylinder; the column can be removed along with these elements.

5. Remove the pedal location brackets, then unscrew the nut, remove the washer and remove the shaft until the clutch pedal is removed from the suspension. Take away the pedal thrust washers.

Material copied from this website (www.OPELBOOK.ru)

6. Installation is carried out in the reverse order, lubricate the shaft. Adjust the clutch cable as described in Chapter 3, then check the clutch pedal adjustment as described in Chapter 2.