Main Astra Corsa Insignia Kadett Omega Vectra Zafira Others Articles

Corsa B (1993-2000) Corsa C (2000-2006, petrol) Corsa C (2000-2006)

Removal and installation the front protective strip (Opel Corsa C)

Contents: Removal ⬇ Installation ⬇

Removal

Removal

Remove the front protective strip.

Note: To avoid damaging the paintwork when removing the protective strip, use a plastic wedge.

Install a plastic wedge and pry up the front protective strip.

Source is on this resource: www.OpelBook.ru

Installation

Install the front protective strip.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Kornev Georgy

Share information:

Previous articles

Opel Corsa C: Exterior

Next articles

Removal and installation the entrance molding
Removal and installation the rear bumper — removal and installation
Removal and installation the protective sheathing inside the wing
Wing replacement — removal and installation
Removal and installation the front beam holder (impact limiter)
Removal and installation the front bumper

Removal and installation the water repellent
Replacing the additional roof frame seal
Removal and installation the hood — removing and installing

See similar ones from other Opel car manuals:
▶ Checking the condition of the protective covers of the… Opel Frontera A (1991-1998, petrol)
▶ Bottom view of the front — C 16 SE engine Opel Astra F (1991-1998, petrol)
▶ Front direction indicators Opel Insignia A (2008-2017)
▶ Front wheel drive Opel Kadett E (1984-1995)
▶ Front view from below (model 1.8 GL Saloon) Opel Omega A (1986-1993)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

We want your visit to be comfortable 🤝! We use cookies 🍪 to make that happen.