Removing
Loosen the lining of the outer contour of the front left and right wheel arches, unscrew the nut 1.
Slightly pull out and fix the overlay of the outer contour of the wheel arch.
Loosen the upper part of the front bumper, unscrew screw 2.
Loosen the protective lining of the wing on the left and right sides, unscrew the screw 1 and 3.
Loosen the lower part of the front bumper, remove expansion rivet 4.
Remove the front bumper.
Release the side bumper from the guide bar.
Installation
Install the front bumper.
Fix the bumper in the guide rail.
Fasten the lower part of the front bumper, install the expansion rivet.
Fix the fender protection bumper on the left and right sides, tighten the screws.
Fix the upper part of the front bumper, tighten the screws.
Fasten the outer contour of the front left and right wheel arches, tighten the nuts.
Visitor comments