Removal and installation the rear wiper motor (Opel Corsa B)

1. Mark the position of the wiper blade on the glass with adhesive tape for subsequent installation.

2. Fold back the rear wiper arm protective cover and loosen the nut. Remove the arm and spacer sleeve.

Rear wiper arm mounting nuts



3. Loosen the nut (arrow) on the wiper shaft. On the model Tigra the nut is covered with a cap - remove it.

4. Loosen the screws securing the inner trim of the tailgate and remove it (see Chapter Body).

5. Disconnect the windshield wiper motor connector.

6. Remove the screws securing the electric motor to the holder and disconnect the ground wire.







Text copied from an internet website: Opelbook.ru

7. If a new electric motor is being installed, set it to the parking position by connecting the connector and starting the electric motor. Then stop it with the wiper switch and let it come to the end position.

8. Install all removed components.