2. Remove the rear wheel from the vehicle.
3. Remove the rear fender liner from the car body.
4. Unscrew the two upper bolts (1) shock absorber mountings.
Note. Replace bolts (1) new after each removal., Before installing, apply a locking compound to the threads of the bolts. Tightening torque: 100 Nm.
5. Remove the bottom bolt (2) shock absorber.
Note.
- Replace shock absorber lower bolt with a new one after each removal.
- Final tightening of the bolt should be done after the vehicle is fully lowered to the ground.
- Tightening torque: 150 Nm + 60-75°.
6. If equipped, disconnect all electrical connectors.
7. Remove shock absorber (3).
8. Installation is made in an order, the return to removal.
Visitor comments