Removing
1. Raise and secure the vehicle.
2. Remove the rear wheels from the vehicle.
3. Remove the rear muffler assembly.
4. To turn away fastening of trailing arms of a suspension bracket to a body.
5. Remove the rear suspension springs.
6. Remove the parking brake cables from the trailing arms.
7. Without disconnecting the brake hoses, remove and fix the brake calipers on the car body.
8. To turn away the bottom bolts of shock-absorbers.
9. Support the rear subframe using a suitable hydraulic jack.
10. Mark the position of the rear subframe relative to the body with a can of paint.
11. Loosen the bolts (1) rear subframe mountings.
12. Lower the rear subframe just enough to access the rear anti-roll bar bracket bolts.
13. Disconnect the stabilizer bar (1) from racks (2).
14. Unscrew the fastening bolts (1) and remove staples (2) bars of the stabilizer bar.
15. Remove the anti-roll bar (4) from the stretcher (5).
Installation
1. Use a suitable hydraulic strut to unload the rear suspension before tightening the bolts to the correct torque.
2. Install the anti-roll bar on the subframe.
3. Install the stabilizer bar mounting brackets and tighten the new bolts to 22 Nm, then tighten another 30°.
4. Connect the anti-roll bar (1) to the uprights (2). Tighten the fastening nuts to 50 Nm.
5. Raise the rear subframe into place.
6. Install bolts (1) rear subframe mountings.
7. Install the lower shock absorber bolts.
8. Install the rear brake calipers.
9. Install the trailing arm bracket bolts.
10. Install the rear suspension springs.
11. Remove the hydraulic strut from under the rear subframe.
12. Install the parking brake cables on the trailing arms.
13. Install the rear muffler assembly.
14. Install the rear wheels on the car.
15. Lower the car.
Visitor comments