2. Remove the rear wheel from the vehicle.
3. Remove inner mount (1) adjusting rod.
Note.
- When installing, only the nut should be tightened, the bolt should not turn.
- Tightening torque: 150 Nm.
4. Loosen the outer bolt (2) adjusting rod.
Note.
- Replace bolt (2) new after each removal.
- Tightening torque: 150 Nm + 60°+ 15°.
5. Remove adjusting rod (3) rear suspension.
6. Installation is made in an order, the return to removal.
Note. A suitable hydraulic jack must be used to relieve the suspension while tightening the screw connections.
7. After installation, check and adjust the rear wheel alignment angles.
Visitor comments