Removing
Disconnect the heater rods located under the dashboard from the air distributor housing. A - heater rod 260 mm long, B - air distribution rod 235 mm long.
Unscrew the middle cover at the points indicated by the letter "X".
Remove cover from holders.
Pull out the multi-pin plug of the electrical switches.
Unscrew the regulator at the points marked with the letter "X", and take it out.
Installation
Install the regulator with rods, connect the rods to the air distributor housing.
Screw the regulator.
Close flaps 10 and 11 in the air distributor housing.
Position levers -X- and -Y- on "zero".
Firmly fasten tie rods -A- and -B-.
Connect the multi-pin plug of the electrical switches.
Install the cover into the holders on the dashboard and secure it with two screws.
Visitor comments