Contents: Friction clutches ⬇ Thickness of spare parts supplied…⬇ Thickness of snap rings supplied as…⬇ Thickness of thrust washers supplied…⬇ Thickness of thrust washers supplied…⬇ Centrifugal governor ⬇ Differential ⬇ Data for checking oil pressure ⬇ Gear shift speeds with selector…⬇ The speed at which forced reverse…⬇
Friction clutches
*Cars with engines "13N", "13S".
**Cars with engine "16S".
Band brake piston marking:
- cars with engine "13N": 1;
- cars with engine "13S": 1;
- cars with engine "16S": 3.
Diameter of valve box mounting balls, mm: 6.35.
Band brake drive piston rod marking:
- without groove: extended length rod;
- 1 groove: medium length rod;
- 2 grooves: short rod.
Secondary shaft axial clearance, mm: 0.10-0.84.
Thickness of spare parts supplied retaining rings for adjusting input shaft axial clearance
Clearance between sun gear and input clutch drum, mm: from -0.13 to +0.33.
The retaining rings supplied as spare parts have different thicknesses and are marked with color codes.
Thickness of snap rings supplied as spare parts for adjusting clearance between sun gear and input clutch drum
Material copied from this portal www.OPELBOOK.ru
The gap between the reverse clutch housing and the 1st gear clutch, mm: 0.8-1.7.
Thickness of thrust washers supplied as spare parts for adjusting the clearance between the reverse clutch housing and the 1st gear clutch
Gap between differential box and gearbox housing, mm: 1.12-0.82.
Thickness of thrust washers supplied as spare parts for adjusting the clearance between the differential box and the gearbox housing
Axial clearance between satellites and crosspiece of input planetary gear, mm: 0.24-0.69.
Centrifugal governor
Marking:
- cars with engines "13N", "13S": 14C
- cars with engine "16S": 21C.
Differential
Number of crown gear teeth: 70.
Number of teeth of sun gear: 30.
Data for checking oil pressure
* The duration of the check should not exceed 5 seconds.
** The numerator shows data for cars with engines "13N", "13S", and in the denominator for cars "16S".
Gear shift speeds with selector lever in position "D"
Maximum speed at position "1" of the selector lever, km/h:
- cars with engines "13N", "13S": 55;
- cars with engine "16S": 60.
Maximum speed at position "2" of the selector lever, km/h;
- cars with engines "13N", "13S": 105;
- cars with engine "16S": 110.
The speed at which forced reverse switching occurs
Visitor comments