Note: When installing, use new cylinder head bolts, a new cylinder head gasket and a new toothed drive belt. Tightening torques in Specifications (as stated in Section 2A) only apply to the latest bolts available from Opel. The tightening torques of the earlier types of bolts are different. Please consult with your supplier.
Removing
1. Part of the gaskets can be removed with the intake manifold, or the intake manifold can be separated from the cylinder head before removing it, as described in Section 4B.
2. Proceed as described in Chapter 8, paragraphs 17-19 inclusive.
3. Remove the cover of the breaker-distributor and high voltage wires, guided by Section 5.
4. Remove the bolt securing the crankcase breather pipe bracket to the end of the cylinder head.
5. Perform a final check to ensure that all relevant hoses, pipes and wires are disconnected.
6. Continue as described in Chapter 8, paragraphs 26-31.
Installation
7. Proceed as described in Chapter 8, points 32-38 inclusive, but in conclusion, make sure that all relevant hoses, coarse, wires, etc., have been securely connected again.
Visitor comments