Photo 9.1. Removing the ventilation plug from the gearshift mechanism cover.
2. Remove the retaining ring from the top of the guide pin (see photos).
Photo 9.2A. Gearshift Cover (view from inside).
Photo 9.2B. Removing the retaining ring from the shift lever guide pin.
3. Remove the retainer, spring and intermediate shift lever (see photo).
Photo 9.ZA. Removing the retainer from the guide pin of the shift lever.
Photo 9.3B. Removing the shift lever.
4. Knock out the pin and disconnect the shift finger from the rod. Remove both parts from the lid (see photos).
Photo 9.4. Removing the cylindrical pin from the shift lever.
5. If the flexible joint on the gear shift shaft is worn, cut off the rivet to disassemble it and install new parts. The pin and snap ring must also be replaced.
6. Replace the seal in the gearshift mechanism cover.
Visitor comments