Four-wheel drive control unit (Opel Frontera B)

Removal

Disconnect the cable from the negative battery terminal.

Remove the center console (see the relevant chapter).

Remove 2 screws and remove the 4WD control unit (arrow) from the floor.

Remove 2 screws and remove the 4WD control unit (arrow) from the floor.

Disconnect the connector from the four-wheel drive control unit.

Installation

Connect the connector to the 4WD control unit.

Install the 4WD control unit and secure with 2 screws.

Install the center console (see the relevant chapter).

Connect the cable to the negative terminal of the battery.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Chernov Alexander

Share information:

Opel Frontera B: Manual gearbox MUA5C

Transfer case mode switching drive
Transfer case rods and forks
Transfer case rear housing
Removal and installation the transfer case
Shafts and gears
Shift forks and rods

Replacing the front seal of the output shaft of the transfer case
Replacing the rear seal of the output shaft of the transfer case
Driven gear of vehicle speed sensor
Gearbox and transfer case control levers

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet