The DIS ignition control unit is located on the flywheel side of the cylinder head. It contains two twin ignition coils as well as an ignition signal conditioner.
1. Disconnect the electrical wiring from the DIS ignition control unit.
2. Turn out three bolts of fastening of the block of management by ignition DIS to a bed of a camshaft.
Bolts of fastening of the block DIS
3. Install the DIS ignition control unit on the camshaft bed and tighten the block fasteners with force 8 Nm.
4. Connect the wiring at the DIS ignition control unit.
Visitor comments