Rope replacement
1. We prepare the car for work (see «Preparing the car for maintenance and repair»),
2. For convenience, remove the battery (see «Battery - removal and installation»).
3. Disconnect the cruise control control unit drive cable from the throttle assembly (see «Throttle assembly - removal, gasket replacement and installation»).
4. Turn the cable sheath latch.
5. Remove the tip of the cable from the connector.
6. Remove the cable.
7. Install the parts in reverse order.
Removal and installation of the block
1. Remove the battery (see «Battery - removal and installation»).
2. Press the latch and disconnect the block of the wiring harness of the cruise control unit.
3. Using the TORX T30 key, unscrew the three bolts securing the cruise control unit and remove it.
4. Disconnect the drive cable (see above).
5. Remove the block.
6. Install the parts in reverse order.
Visitor comments