Driven gear of vehicle speed sensor (Opel Frontera B)

Removal

Disconnect the cable from the negative battery terminal.

Disconnect the connector from the vehicle speed sensor.

Unscrew and remove the vehicle speed sensor from the speedometer drive gear housing.

Mark the location of the speedometer drive gear housing. Remove the bolt, remove the retaining plate and take out the casing with the speedometer drive gear.

Source is on this resource: Opelbook.ru

Installation

In accordance with the previously applied marks, install the housing with the driven gear of the vehicle speed sensor into the transfer case, install the retaining plate and secure with the bolt, tightening it to a torque of 15 N·m. When installing a new vehicle speed sensor, correctly align the housing with the driven gear of the vehicle speed sensor with the retaining plate.



Screw the vehicle speed sensor onto the speedometer drive gear housing and tighten it to 27 N·m.



Connect the connector to the vehicle speed sensor.

Connect the cable to the negative terminal of the battery.