- A. Do not start the engine without making sure the contacts at the battery terminals are secure.
- b. Do not use the charger for winding "lighting a cigarette".
- V. Do not disconnect the battery while the engine is running.
- d. Before charging the battery, disconnect it from the system.
- e. When the ignition is on, do not disconnect or connect the plug of the control unit and the plugs of other electrical equipment of the system.
- e. Remove the control unit if the machine must be exposed to temperatures above 80 degrees Celsius (for example in a paint drying oven).
- and. Always disconnect the command relay plug before checking cylinder compression.
2. When working with the fuel system, maintain absolute cleanliness, because If dirt gets into the fuel lines, it can cause damage to system components.
3. When searching for wiring defects, do not "while away" wires on "mass" and do not use the test lamp to determine the voltage. Use a good multimeter.
4. Observe normal safety precautions when working with fuel lines (see section 1).
Visitor comments