1. Remove the clutch (see chapter 5).
2. Although the flywheel bolt holes are specifically offset so that the flywheel can only be installed the correct way, it will be easier to install the flywheel if you mark the position of the flywheel relative to the crankshaft flange before removing it.
3. Remove the clutch release bearing and guide sleeve (see chapter 5).
4. Block the flywheel ring gear and remove the bolts securing the flywheel.
5. Remove the flywheel.
6. Install the flywheel in the reverse order. Apply a small amount of thread locking compound to the bolts.
Visitor comments