Gas pedal and gas control drive (Opel Frontera A)

To properly control the engine speed, the gas pedal and control drive must be adjusted correctly.

1. Remove the retaining cap from the pedal stop inside the vehicle.

2. Use a ruler to measure the length of the protruding part of the screw. It should be 14±0.5 mm. After measuring, close the locking cap again.

3. Check that the gas pedal is in the idle position and the gas lever at the throttle body is in the closed position.

4. Pull the outer gas pedal bushing toward the pedal and check to see if the clip is level with the bushing in the groove next to the tip.

Original source on the website [OpelBook]

5. If necessary, move the clamp. After this, check the idle and full throttle positions of the lever at the throttle body.