2. Loosen and remove the nuts from the drive spindles. Mark the sequence of installation of gaskets and washers.
Figure 12.30. Windscreen wiper arm drive spindle nut - indicated by arrow
3. Open the hood and remove the water deflector (if installed) — see Figure 12.31.
Figure 12.31. Engine top water deflector. The arrows indicate the attachment points
Text copied from a web portal OpelBook
4. Disconnect the multi-plug electrical wiring from the windshield wiper motor (see photo 36.4).
Photo 36.4 Windshield wiper motor
5. Disconnect the motor ground wire.
6. Loosen the motor mounting screws and remove the entire motor and connecting parts from the vehicle.
7. Disconnect the lever from the motor. When loosening the nut, count the number of turns using an open-end wrench, otherwise you may damage the teeth of the internal drive gear when reinstalling.
8. Disconnect the wiper motor from its support plate.
9. Installation is carried out by performing the above steps in reverse order, do not forget to hold the upper part of the motor casing when tightening the lever nut.
Visitor comments