2. Detach and slide back the water repellent plastic shield as necessary to gain access, and then disconnect the control arm (1) from the door lock (see Figure 11.24).
Figure 11.24. Outside door handle fastenings 1. Control lever; 2. Mounting screws/nuts
3. Remove the screws (2) and remove the handle from the door panel.
4. Reinstallation is carried out by performing the above steps in reverse order, do not forget to adjust the position of the control lever using threaded fasteners, as shown in Figure 11.25. (see )
Figure 11.25. Installation diagram of the lock control lever: X = 8.0 mm (0.31 inches)
Visitor comments