1. Disconnect the battery from the ground.
2. Remove the instrument panel.
3. Turn away bolts of fastening of an arm of a pedal to a cross-beam of the steering mechanism.
4. Remove the lower trim on the driver's side by unscrewing the screws and removing the latches, remove the heater air duct, disconnect the wire from the brake light switch, turn the switch and remove from the pedal bracket.
5. Disconnect the wires from the fuse panel bracket. Unhook the pedal spring.
6. Unsplint and remove the pedal axle.
7. Turn away nuts of fastening of the vacuum amplifier to an arm of a pedal and remove an arm together with a pedal. To do this, remove the pedal bracket from the studs on the cross member, tilt it up and, turning, remove the bracket with the pedal.
8. Mark position of a pedal on an arm, turn away nuts and remove an axis, remove plugs and a spring.
9. The pedal is installed in the reverse order. Lubricate the axle, check the free movement of the pedal. When installing the brake light switch, depress the brake pedal, pull out the switch rod, install the switch in the bracket and connect the wire, release the pedal.
Visitor comments