Removing
1. The automatic transmission ECU is located either in the driver's footwell or behind the glove box, depending on model and year.
2. Disconnect the negative cable from the battery.
3. To locate the ECU, remove the driver's footwell side trim panel and lower instrument panel trim panel (Section 11). If the block is not found, reinstall these panels and remove the glove box assembly (Section 11). The block is attached to the back side of the top edge of the dashboard.
4. Release the block from the fasteners and remove it so that you can press the locking tabs of the wiring connector and remove it.
Installation
5. Installation is carried out in the reverse order. Make sure the wiring is properly connected to the connector.
Visitor comments