Main Astra Corsa Insignia Kadett Omega Vectra Zafira Others Articles

Vectra A (1988-1995, petrol) Vectra A (1988-1995) Vectra B (1995-2002, petrol) Vectra B (1995-2002) Vectra C (2002-2008)

Differential seals — replacement (Opel Vectra A)

Contents: Removal ⬇ Installation ⬇

Removal

1. Drain the transmission fluid (see above).

2. Proceed as described in Section 7A, using transmission fluid to lubricate the new seals

Installation

3. Fill the transmission with clean fluid and check the level as described in Section 1.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Chernov Alexander

Share information:

Previous articles

Opel Vectra A: Automatic gearbox

Next articles

Auxiliary Transmission Fluid Cooler Hoses and Tubes — General Specifications
Driving Mode Selector Panel Illumination Lamp — Replacement
Electronic Control Unit (ECU) — Removal and Installation
Submode switches — removal and installation
Central control panel — removal and installation
Driving mode selection lever — removal and installation

Transmission Fluid Temperature Sensor — Removal and Installation
Input/Output Shaft Speed Sensors — Removal and Installation
Transmission — removal and installation
Troubleshooting Automatic Transmissions

See similar ones from other Opel car manuals:
▶ Seals (drive shafts) on the differential side Opel Astra F (1991-1998, petrol)
▶ Replacing crankshaft seals Opel Corsa B (1993-2000)
▶ Checking the oil level in the rear differential clutch of… Opel Insignia A (2008-2017)
▶ Replacing the front camshaft seals of a 16-valve engine Opel Kadett E (1984-1995)
▶ Final Drive Differential Bearing Seal — Replacement Opel Omega A (1986-1993)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

We want your visit to be comfortable 🤝! We use cookies 🍪 to make that happen.