Driving Mode Selector Panel Illumination Lamp — Replacement (Opel Vectra A)

Removal

1. Disconnect the negative cable from the battery.

2. Unpin the drive mode selection panel (two staples on each side) from the central control panel, move it to the side and remove the lamp holder

3. Remove the lamp from the socket.

Installation

4. Installation is carried out in the reverse order of removal.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Chernov Alexander

Share information:

Opel Vectra A: Automatic gearbox

Electronic Control Unit (ECU) — Removal and Installation
Submode switches — removal and installation
Central control panel — removal and installation
Driving mode selection lever — removal and installation
Gear Shift Cable — Removal and Installation
Gear Shift Cable — Adjustment

Auxiliary Transmission Fluid Cooler Hoses and Tubes — General Specifications
Differential seals — replacement
Transmission Fluid Temperature Sensor — Removal and Installation
Input/Output Shaft Speed Sensors — Removal and Installation
Transmission — removal and installation
Troubleshooting Automatic Transmissions

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet