Central control panel — removal and installation (Opel Vectra A)

Removal

1. Remove the drive mode selector lever (see above).

2. Remove the four hex head screws securing the center console to the floor and remove it.

Installation

3. Installation is carried out in the reverse order of removal. Tighten the bolts with the tightening force specified Specifications.

Material copied from this resource [Opelbook.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Chernov Alexander

Share information:

Opel Vectra A: Automatic gearbox

Driving mode selection lever — removal and installation
Gear Shift Cable — Removal and Installation
Gear Shift Cable — Adjustment
Starter interlock — removal and installation
Downshift mechanism — removal and installation
Downshift mechanism — adjustment

Submode switches — removal and installation
Electronic Control Unit (ECU) — Removal and Installation
Driving Mode Selector Panel Illumination Lamp — Replacement
Auxiliary Transmission Fluid Cooler Hoses and Tubes — General Specifications
Differential seals — replacement
Transmission Fluid Temperature Sensor — Removal and Installation

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet