Electric sunroof (5-door vehicle) (Opel Frontera B)

Removal

Disconnect the cable from the negative battery terminal.

Slide the sunshade back.

Remove the sunroof trim (1) from the ceiling.



Remove the alarm sensor (1) from the left side of the ceiling.



Using a flat-blade screwdriver, open the decorative covers located on both sides of the ceiling handle (2).

Remove 2 screws and ceiling handle (2).

Remove 2 screws and remove the left sun visor from the ceiling.



Remove the screws and remove the right and left sun visor support clips from the ceiling.



[Material copied from this resource: OPELBOOK]

Remove the seal (2) of the left front door in the area of the upper trim (1) of the front pillar.



Release the clips and remove the upper trim of the left front pillar.

Remove the sunroof control switch panel from the ceiling.



Remove 3 screws and remove the switch housing from the ceiling.

Disconnect the connector from the electric drive (1) of the sunroof.



Remove the bolts and remove the sunroof electric drive from the roof.

Installation

Install the electric sunroof drive onto the roof and secure with bolts. Before installing the drive, it is not necessary to pre-install it in its original position.

Connect the connector to the sunroof electric drive.



Install the sunroof control switch cover to the ceiling and secure it with 3 screws.

Install the sunroof control switch panel to the ceiling.

Install the upper trim (1) of the left front pillar and make sure that it is securely fastened with the clips.



Install the seal (2) of the left front door in the area of the upper trim (1) of the front pillar.

Install the right and left sun visor support clips to the ceiling and secure with screws.



Install the left sun visor to the ceiling and secure with 2 screws.



Install the ceiling handle (2) and secure it with 2 screws.



Close the decorative covers located on both sides of the ceiling handle.

Install the alarm sensor (1) on the left side of the ceiling.

Install the sunroof trim onto the ceiling until it snaps securely into place with the fasteners.

Connect the cable to the negative terminal of the battery.