See also Chapter Manual.
Switches
Switches are installed on the driver and passenger doors.
1. Gently prying with a screwdriver, release the switch from the door upholstery.
2. Disconnect the electrical wiring and remove the switch.
3. Installation is carried out in the reverse order.
Drive motors
1. Remove the power window (see Removal and installation of a regulator of a window regulator).
2. Turn out three fixing screws and remove the driving electric motor from a regulator of a window regulator.
3. Installation is carried out in the reverse order. On models with programmable windows, set the window to the closed position on the control unit, to do this, sit in the driver's seat and close all doors, turn on the ignition and lower the windows, then raise the windows again and hold the control button pressed for at least two more seconds.
Visitor comments