1. Lower the engine on hoists into the engine compartment and install it on the transmission locating pins.
2. Secure the engine to its mountings.
3. Install and tighten the bolts securing the engine to the bell housing of the transmission.
4. Disconnect the hoists and remove the jack from under the gearbox.
5. Align the white mark on the drive disk with the colored mark on the torque converter and screw in new bolts. Tighten the bolts to the required torque, blocking the starter ring gear to prevent the torque converter from rotating.
b. Reinstall the torque converter cover.
7. Reinstall and secure the starter.
8. Connect the downshift cable.
9. Carry out the operations specified in section 35, paragraphs 17-30.
10. Install the crankshaft pulley and vibration damper (engines 1.6 and 1.8) (see section 35, paragraph 14).
11. Adjust the downshift cable (see chapter 6).
Visitor comments