Warning: Never reuse brake fluid that has just been drained from the hydraulic system.
Install a brake system hydraulic bleeder on the reservoir and seal the system. Start the engine.
Replace the brake fluid starting from the caliper located at a greater distance from the refill tank.
Clean the bleed nipple and attach a clean transparent hose to it, lowering the other end into a container partially filled with brake fluid. Loosen the bleed screw half a turn and wait until fresh brake fluid without air bubbles starts to flow out of the screw, then tighten the bleed screw.
Add fresh DOT 4 brake fluid to the reservoir up to the MAX mark.
Warning! For vehicles with an anti-lock braking system, remove the ABS fuse located in the fuse box mounted on the battery support to properly pump the hydraulic brake drive.
Do not press the brake pedal when the engine is off, as this may damage the servo.
Visitor comments