Remote control of locks (Opel Frontera B)

The remote control system allows you to activate and deactivate:

• central locking;
• anti-theft system;
• a system for alerting about the activation and deactivation of the anti-theft device.

The remote control operates at a distance of up to 3 meters. The operating distance of the transmitter depends on the area where the transmitter is used. For example, when stopping a car near police stations, government buildings, radio stations, airports, transmitting antennas, etc.



To prevent damage to the transmitter, do not drop it, store it in damp or humid places, or expose it to heat or direct sunlight.



When the remote control is in operation, the LED on the remote control flashes and the vehicle's hazard warning lights come on briefly.

Locking

Press the back button of the remote control, the LED on the remote control will flash.

• The doors and fuel filler cap are locked.
• The lamp that lights up when the door is opened turns off.
• The mechanical anti-theft device is activated.

For safety reasons, the vehicle cannot be locked with the remote control if the key is in the ignition switch.

To activate the anti-theft system:

• Press the rear button of the remote control and hold it for 10 seconds, the LED on the remote control will flash.
• The buttons on all doors are locked and prevent the doors from opening.

Unlocking

Click on the button remote control, and the LED on the remote control will flash.

• The door locks and fuel filler cap are unlocked;
• The mechanical anti-theft device is switched off.
• The warning signal is switched off.
• The lamp turns on when the door is opened.

Note: If the central locking system cannot be operated from the remote control, this may be due to the following reasons:

• using the remote control outside its range;
• dead battery in the remote control;
• repeated and consecutive use of the remote control outside its operating range (for example, at a great distance from the car). Synchronize the remote control;
• in the presence of powerful radio waves from external radiation sources.

Replacing the battery in the remote control

Replace the battery according to the regulations or when the remote control's range becomes reduced.



Use a screwdriver to release the latch and open the remote control cover.

Replace the battery, making sure to connect the battery correctly.

Close the cover of the remote control until it snaps into place.

If the battery is replaced within 3 minutes, the remote control does not need to be synchronized.

Remote control synchronization

When the battery is discharged and replaced, it is necessary to synchronize the remote control.

• Turn on the ignition and wait 30 seconds for synchronization to occur.
• Briefly press one of the two buttons on the remote control, while the key must be in the ignition switch.
• The central locking system should lock and unlock the doors, indicating that the remote control is synchronised.