Removing
1. Take out the bracket (1) and disconnect the parking brake cable.
2. Disconnect the trailing arm from the chassis and rear axle. One of the lever mounting bolts (2) shown in the illustration. The second bolt is on the other end of the lever.
Installation
The trailing arm is installed in the reverse order of removal. The lever has a parking brake cable attachment plate. The plate should be closer to the bridge during installation.
Be careful not to get oil on the rubber bushings and mating parts of the lever.
1. Fasten the fastening bolts and nuts on both sides first by hand.
2. Lower the vehicle onto the wheels and tighten the nuts and bolts at both ends to 165 Nm.
Visitor comments