And — the Lever of a screen wiper
B - Raise to the top position
C - Protective cap of the nut
D - Mounting nut with washer
Windscreen wiper arm
1. Turn the wipers on and off again so that the levers return to the parking position and mark the position of the brushes on the glass with tape.
2. Using a screwdriver, remove the cover from the arm shaft spindle.
3. Loosen the fixing nut and remove the small washer from the spindle (see illustration Wiper arm mounting diagram).
4. Move the lever away from the glass and remove it from the splined spindle trunnion. If the lever «stuck» and cannot be removed, gently pry it with a screwdriver - try not to damage the paintwork of the body panel.
5. If necessary, remove the brush from the lever (see chapter Current service).
6. If removed, replace the brush to protect the glass when installing the lever.
7. Clean the slots in the lever and on the spindle trunnion, then install the lever and press the brush against the glass - make sure that the brush is correctly placed on the glass relative to the marking applied with adhesive tape.
8. Place a washer on the spindle, screw on the fixing nut and tighten it firmly.
Rear window wiper arm (models Hatchback and Wagon / Zafira)
1. Turn the wiper on and off again so that the lever returns to the parking position and mark the position of the brush on the glass with tape.
2. Pry off with a screwdriver, remove the cover from the spindle of the lever axis, give the fixing nut and remove the small washer.
3. Move the lever away from the glass and remove it from the splined spindle trunnion. If the lever «stuck» and cannot be removed, gently pry it with a screwdriver - try not to damage the paintwork of the body panel.
4. If necessary, remove the brush from the lever (see chapter Current service).
5. If removed, replace the brush to protect the glass when installing the lever.
6. Clean the splines in the lever and on the spindle trunnion, then install the lever and press the brush against the glass - make sure that the brush is correctly placed on the glass relative to the marking applied with adhesive tape.
7. Place a washer on the spindle, screw on the fixing nut and tighten it firmly.
Visitor comments