If your car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting the battery!
You will need two special DIN puller tools.
Car radio
1. Using an Allen key, remove the mounting screws at the four corners of the car radio control panel.
2. Insert the DIN pullers into the holes from the mounting screws - the pullers should snap into the internal assembly fasteners.
3. Move the puller brackets apart and carefully remove the radio assembly from the central section of the instrument panel - note that the unit's contact connectors have a quick-release design.
4. If necessary, remove the mounting screw, bend the locking tabs on the sides and remove the radio mounting box from the instrument panel. Disconnect the electrical wiring and antenna cable connectors at the rear of the mounting box.
A — Screw for fastening the car radio mounting box (the locking tabs are located on the sides of the front edge of the box)
B - Disconnecting the antenna cable
C - Disconnecting the electrical wiring (zafira models)
D — Removing the car radio mounting box (astra models)
A.
B.
C.
D.
5. Installation is carried out in the reverse order. Make sure that the contact connectors are connected correctly. Finally, enter the security code to activate the audio system.
CD player
1. Remove the glove box (see Chapter Body).
2. Release the fasteners and remove the player assembly with the support bracket from the glove compartment, making sure that the electrical wiring is released.
3. Remove the mounting screws and remove the player from the support bracket.
4. Installation is carried out in reverse order.
Navigation system
Type NDCR 3000
1. Press the release button and remove the control panel from the navigation unit.
2. Insert the DIN pullers into the special holes on both sides of the block - the pullers should snap into the internal assembly retainers.
A — Screw for fastening the car radio mounting box (the locking tabs are located on the sides of the front edge of the box)
B - Disconnecting the antenna cable
C - Disconnecting the electrical wiring (zafira models)
D — Removing the car radio mounting box (astra models)
A.
B.
(Material copied from this website www.OpelBook.ru)
C.
D.
3. Move the puller brackets apart and carefully remove the navigation unit from the instrument panel.
4. If necessary, remove the mounting screws and remove the navigation unit mounting box from the instrument panel. Disconnect the electrical wiring and antenna cable connectors at the rear of the mounting box.
5. Installation is carried out in reverse order.
Other types
The procedure is similar to the one above (see Car radio).
Navigation system control unit
The procedure is similar to the one above (see CD player).
Visitor comments