Caution: Make sure the ignition is off.
15.1. Left-hand drive vehicles
Removal
1. Disconnect the wiring connector 1 (figure 2.74). Remove sensor 2 from the support bracket by unscrewing the three nuts securing it.
Installation
2. Installation is carried out in the reverse order of removal.
Figure 2.74. Disconnect wiring connector 1. Remove sensor 2 from the support bracket by unscrewing the three nuts securing it.
15.2. Right-hand drive vehicles
Removal
1. Disconnect wiring connector 1, rod 3 from sensor 2 (figure 2.75). Remove sensor 2 from the support bracket by unscrewing the three nuts securing it.
(Article published on the website: OpelBook.ru)
Installation
2. Installation is carried out in the reverse order of removal.
Figure 2.75. Disconnect wiring connector 1, rod 3 from sensor 2. Remove sensor 2 from the support bracket by unscrewing the three nuts securing it.
Visitor comments