Contents: Removal ⬇ Installation ⬇
The injectors are attached to the fuel rail using clamps. Fuel circulates continuously around the perimeter of the injector body. The constant movement of gasoline prevents the formation of gasoline vapor bubbles and helps with cold engine starting.
Removal
1. Remove the carpet under the left seat and the battery cover 1 (figure 2.58).
Figure 2.58. Remove the carpet under the left seat and the battery cover 1.
2. Disconnect the battery, disconnect the wiring connector 1 from the pressure sensor in the hydraulic power steering, the fuel line from the fitting 2 of the fuel rail (figure 2.52).
3. Loosen the two bolts 4 securing the fuel rail casing, two bolts 5 securing the fuel rail and remove the fuel rail (figure 2.59). Disconnect wiring connector 6.
Figure 2.59. Loosen two bolts 4 securing the fuel rail casing, two bolts 5 securing the fuel rail and remove the fuel rail. Disconnect wiring connector 6.
4. Remove the injector retainers and the injectors themselves.
Installation
5. Installation is carried out in the reverse order of removal. The seals and injector retainers must be replaced. Install the new retainer onto the injector and then push it down until the clip is secured to the fuel rail (figure 2.60). Tighten the fuel rail mounting bolts (9 Nm).
Figure 2.60 Install the new retainer onto the injector, then press down on it until the clip is secured to the fuel rail.
Visitor comments