Pic. 1. Instrument cluster
1 - tachometer electronic type shows the engine speed. The scale has divisions from 0 to 80, the division value is 5. To find out the crankshaft speed in minutes–1, you need to multiply the tachometer readings by 100. The red zone of the scale means a dangerous mode of engine operation.
2 - signal lamp for emergency oil pressure drop (with red filter) lights up when the ignition is switched on and warns that the pressure in the engine lubrication system is below normal. Immediately after starting the engine, the lamp should go out.
Attention! The movement of the car with a burning lamp is prohibited, as it will lead to engine damage.
3 - control lamp for turning off the traction control system (with yellow filter) lights up flashing when the system is turned off.
4 - a signal lamp of a pillow of safety of the forward passenger (with yellow filter) lights up when the ignition is turned on, if the airbag is on (see Use of child seats). If the airbag is deactivated, the airbag symbol in the lamp becomes crossed out.
5 – a signal lamp of a reminder of the need to press the brake pedal (with yellow filter) functions if the vehicle is equipped with an electric parking brake. Lights up when the parking brake is applied, reminding the driver to release the car by pressing the brake pedal before starting to move.
6 – a signal lamp of system of dynamic stabilization (with yellow filter). A permanently lit lamp indicates a system malfunction.
Note. With a constant burning lamp, you can continue to move. However, depending on the condition of the roadway, the stability of the vehicle may decrease. Contact the service for troubleshooting.
The flashing of the lamp indicates that the system is actively intervening in the control process. It is possible to reduce engine power and automatically brake the car. In the event of a forced shutdown of the system by the driver, the signal lamp 24 lights up.
7 - signal lamp of the discharge of the storage battery (with red filter) lights up when the ignition is turned on. Immediately after starting the engine, the lamp should go out. The lamp burning or glowing half-heartedly with the engine running indicates a lack of charging current caused by a malfunction of the generator or voltage regulator, as well as weak tension (or a cliff) generator drive belt.
Attention! It is forbidden to drive a car with a burning lamp, since, in addition to completely discharging the battery, this may indicate a short circuit in the charging circuit, which can lead to a fire.
8 - immobilizer malfunction signal lamp (with yellow filter) lights up with a flashing light when there is a malfunction in the system. Starting the engine is not possible.
9 – a signal lamp of not fastened seat belt of the driver (with red filter) lights up constantly when the ignition is turned on and goes out after the driver's seat belt is fastened. Lights up with a flashing light if the engine is started with the belt not fastened, for 100 seconds or until the belt is fastened.
10 - signal lamp of the state of the brake system and the inclusion of the parking brake (with red filter) Illuminates with the ignition on when the brake fluid level in the brake master cylinder reservoir is too low and the power parking brake lever is raised.
11 - coolant temperature gauge in the engine cooling system. The red zone warns of engine overheating. If the arrow goes into the red zone, you should stop, let the engine cool down and eliminate the cause of overheating.
12 - signal lamp of the minimum reserve of fuel in the tank (with yellow filter) constantly lit when there is fuel left in the tank for about 80 km.
Attention! If possible, avoid driving on reserve fuel. The operation of the electric fuel pump in the absence of a continuous supply of fuel with air entering the system will lead to the failure of the pump!
13 - fuel gauge. The red zone means the reserve fuel balance.
Attention! If possible, avoid driving on reserve fuel. The operation of the electric fuel pump in the absence of a continuous supply of fuel with air entering the system will lead to the failure of the pump!
14 - speedometer Shows how fast the car is currently moving. The scale is graduated from 0 to 270 km/h, the division value is 10 km/h.
15 - signal lamp for a malfunction of the anti-lock braking system (with yellow filter) lights up when the ignition is on for 3 s. In the event of a system failure, the lamp is permanently on.
Attention! When the lamp lights up, contact a car service, as braking in all cases will occur without the participation of the anti-lock braking system.
16 - signal lamp of clogging of the particulate filter of the diesel engine (with yellow filter).
17 - control lamp for turning on the rain sensor (with green filter) functions if the vehicle is equipped with an automatic windshield wiper control system.
18 – signal lamp of system of adaptive control of light of headlights (with yellow filter) function only if the vehicle is equipped with adaptive headlight control. A steady flashing light indicates that the system has switched to symmetrical dipped beam mode. Flashing for about 4 seconds after the ignition is switched on means that the system is on. Continuous burning of the lamp indicates a malfunction in the system.
Note. If the lamp is constantly on, contact the service for troubleshooting.
19 – a signal lamp of system of the electric drive of a parking brake (with yellow filter). A blinking lamp indicates that the system is in service mode. To return the system to normal mode, stop the vehicle, apply and release the parking brake again. Constant burning means a malfunction in the system.
Attention! If the lamp is constantly on, contact a car service immediately, as the parking brake functions with reduced efficiency.
20 - warning light for upshift recommendation (with green filter) Illuminates when the engine speed is high, reminding the driver to upshift in order to save fuel.
21 – a control lamp of inclusion of preheating of the diesel engine (with yellow filter).
22 – a control lamp of inclusion of back fog lamps (with yellow filter) lights up when the rear fog lights are on.
23 – a control lamp of inclusion of headlights of a daylight (with green filter) Illuminates when the daytime driving light is turned on.
24 - signal lamp for disabling the dynamic stabilization system (with yellow filter) (see pos. 6 above).
25 – a control lamp of inclusion of the right index of turn (in the form of an arrow with a green filter) lights up with a flashing light when the right turn signal is turned on (in sync with it). The blinking of the control lamp at a double frequency or its constant burning indicates a lamp burnout in any right turn indicator.
26 – a control lamp of inclusion of antifog headlights (with green filter) lights up when the fog lights are on.
27 - signal lamp of reduced engine power (with yellow filter) lights up if the engine power is permanently reduced due to some kind of malfunction.
Note. If the lamp is constantly on, contact the service for diagnostics and troubleshooting.
28 - button for resetting the daily mileage counter. To reset the readings, press the button for a few seconds with the ignition on.
29 - signal lamp of the tire pressure monitoring system (with yellow filter) lights up with a flashing light if there is a malfunction in the system or if a wheel without a pressure sensor is installed (for example spare). Lights up while driving and stays on when the tire pressure drops.
Attention! If the light stays on, stop immediately and check the tire pressure.
30 - central information display. On-board computer readings are shown on the display (see On-board computer), as well as total and daily mileage counters. Electronic counter of total (odometer) and the daily mileage of the car shows the distance traveled in kilometers. After a run of 1,000,000 km, a new odometer reading cycle begins. The readings of the daily run counter are reset by pressing the button 28 and keeping it pressed for several seconds.
31 - signal lamp for low fluid level in the washer reservoir (with yellow filter) Illuminates when the liquid level in the tank is too low.
32 - signal lamp of an open side door (with red filter) lights up if not closed (or not tightly closed) one of the side doors when the key is in the ignition.
33 - signal lamp for the need for maintenance or repair (with yellow filter) Illuminates when the odometer indicates that the vehicle needs to be serviced soon. Additionally, the central information display 30 displays a warning message or code, as well as informational messages (see On-board computer).
34 – a control lamp of inclusion of a high beam of headlights (with blue filter) lights up when the high beam headlights are on.
35 – a signal lamp of inclusion of a lay brake with the electric drive (with red filter) lights up continuously when the parking brake is applied. The flashing of the lamp indicates that the parking brake is not fully released.
Note. If the warning light is flashing, turn the ignition on, depress the brake pedal and try to reset the system by disengaging and reapplying the parking brake. If the lamp continues to flash, contact the service immediately.
36 - control lamp for turning on side lights (with green filter) lights up when the side lights are turned on with the switch handle A in block 30 (see Dashboard, pic. 1).
37 - control lamp of the automatic light control system (with green filter) lights up when the system is turned on (if it is installed on the car) switch handle A in block 30 (see Dashboard, pic. 1).
38 – a control lamp of inclusion of the left index of turn (in the form of an arrow with a green filter) lights up with a flashing light when the left turn signal is turned on (in sync with it). The blinking of a control lamp with a doubled frequency or its constant burning indicates a burnout of a lamp in any indicator of the left turn.
39 - signal lamp for a malfunction of the power steering (with yellow filter) lights up for a few seconds when the ignition is switched on. If the lamp is on when the engine is running, this means that the amplifier is faulty. If, after stopping the engine and restarting it, the lamp does not light up, it means that the amplifier's performance has been restored.
Attention! If the power steering malfunction lamp is constantly on, contact the service immediately, as a sudden failure of the power steering while driving can lead to serious consequences.
40 – a control lamp of system of automatic maintenance of speed (Cruise control) (with combined white and green color filter). Lights up white when the system is turned on. In the process of memorizing a certain speed, it lights up green.
41 – a signal lamp of a control system of the engine (with yellow filter). Lights up when the ignition is turned on and lights up when the engine is started. Immediately after starting the engine, the lamp should go out. If the lamp comes on when the engine is running, it indicates a malfunction in the engine management system. In this case, the control unit switches to the backup program, which allows you to continue driving. When the lamp lights up, it is necessary to check the electronic control unit on the diagnostic equipment and eliminate the malfunction.
Attention! Prolonged operation of the car with a burning lamp is not recommended, as it can lead to an increase in fuel consumption, a deterioration in the traction characteristics of the car and engine breakdowns.
Visitor comments