2. Checking the condition of the cooling system components should be carried out after the power unit has completely cooled down (at least after 3 hours after the engine has stopped).
3. The procedure for checking the condition and adjusting the coolant level is given in Section 4.
4. Carefully inspect the upper and lower radiator hoses along with the smaller diameter cabin heating hoses located between the power unit and the engine compartment bulkhead. Check the hoses along their entire length and replace any defective components if cracks, bulges or signs of material aging are detected. Small cracks are usually easier to see when squeezing the hose (see accompanying illustration).
Note: The authors of this manual recommend replacing hoses approximately every two years, regardless of their condition
5. Check that all hoses are securely fastened to their fittings/pipes. Coolant leaks usually appear as rusty or white streaks on the surfaces surrounding their source. If the hoses are secured to the fittings/pipes with twist-type clamps, it would be wise to replace them with more reliable worm or screw-type clamps.
6. Using compressed air or a soft brush, remove old leaves, insect remains and other debris from the gaps between the radiator heat exchanger plates. Try not to damage the soft heat exchanger plates or cut your fingers on their sharp edges.
Caution! When disconnecting the battery, always disconnect the negative cable first - connect it last! Refer to the instructions and recommendations in Chapter 5.
Visitor comments