Fuel filter (models with fuel pump) — removal and installation (Opel Vectra A)

Note: Before you begin, see. Chapter 2.

Removal

1. The fuel filter is located on the fuel pump bracket under the rear of the vehicle. Either on the right side of the spare tire well or in front of the fuel tank, depending on the model (see illustrations).





(Source is on the website OPELBOOK.ru)

2. Disconnect the negative cable from the battery.

3. Prepare a container to collect the fuel after removing the filter.

4. Clamp the fuel supply hoses on both sides of the filter to reduce fuel loss when disconnecting the hoses.

5. Loosen the clamp screws and disconnect the fuel supply hoses from the filter.

6. Loosen the clamp bolts and remove the fuel filter from the bracket. Note the orientation of the arrow on the filter housing indicating the direction of flow and the position of the "AUS" (outlet) mark on the end of the filter.

Installation

7. Install in reverse order. Correctly orient the filter according to the marks.

8. Start the engine and check the system for leaks. If there are leaks, turn off the engine immediately and correct the problem without delay.