Fuel pump — removal and installation (Opel Vectra A)

Note: Before you begin, see. Chapter 2.

Removal

1. The fuel pump is located on a bracket under the rear of the vehicle, or on the right side of the spare tire well, or on other models in front of the fuel tank

2. Disconnect the negative cable from the battery.

3. Prepare a container to collect the fuel after removing the extinguisher.

4. Disconnect the electrical wiring from the fuel pump (see illustration).



5. Clamp the fuel supply hoses on both sides of the extinguisher to reduce fuel loss after disconnecting the hoses.

6. Loosen the clamp screws, disconnect the fuel supply hoses from the pump.

7. Loosen the clamp bolt, remove the pump from the bracket

Installation

8. Install in reverse order. Make sure the pump is correctly oriented in the bracket. Push the pump into the rubber bushing of the clamp until it touches the frame on the housing (see illustration).



9. Start the engine and check the system for leaks. If there is a leak, turn off the engine immediately and correct the problem without delay.

Original article on the web portal www.opelbook.ru