Tubes are sold in standard lengths; the kit also includes union nuts. If a tube of a different length is required, it can be made independently from a tube with a diameter of 4.75 mm.
Caution! When working with brake pipes, be careful not to damage the plastic protective layer. If it is damaged, replace the pipe.
Raise the car.
Loosen the union nuts and remove the pipeline.
Close the line leading to the master brake cylinder with a suitable plug, or first pump out the brake fluid from the reservoir.
If possible, lay the new pipeline in the same place where the old one was.
Caution! Do not lay brake pipes between electrical wiring. Otherwise, situations may arise that lead to failure of the brake system or electrical equipment. The distance between pipes and electrical wires must be at least 25 mm.
Visitor comments