Side nozzle (for defogging side windows)
1. Pry off the nozzle with a screwdriver and remove it from "torpedoes".
Side vent of the heater
2. Pull out the rotary grille of the hole by tilting it down and gently pressing it to one side to release the rotating axis.
3. Depending on which side the air vent housing is being removed from, remove either "glove compartment", or the exterior light switch and trim strip.
4. Remove 2 self-tapping screws and pull out the ventilation hole housing from "torpedoes".
Central fresh air vent
5. The rotary grille is removed in the same way as the side opening grille (see paragraph 2).
Ventilation grille for releasing air from the passenger compartment
6. Pry up the grille and carefully pull it out of the fastenings.
A common part
7. Install all parts in reverse order. Before installing the exhaust ventilation grille, coat its fastenings with sealant to achieve a good seal.
Pic. 2.28. Removing the Side Air Nozzle
Pic. 2.29. Removing the rotating grille of the side heater vent
Pic. 2.30. Screws securing the side heater vent housing (shown by arrows)
Pic. 2.31. Removing the Center Fresh Air Vent Housing
Pic. 2.32. Exhaust ventilation grille fastenings (Saloon models)
Pic. 2.33. Exhaust ventilation grille (Hatchback models)
Visitor comments