Engine cover (Opel Corsa C)

1. Depending on the design features and the layout of the units in the engine compartment, some engines are equipped with a protective and decorative cover. Despite the misconception of many, the cover not only gives the engine a more presentable appearance, but also serves to reduce the degree of its contamination and prevents accidental damage to pipelines and other elements (ignition module, various types of hoses, cable lines), located on top of the engine. Do not forget to install the cover in its regular place after completing the work.

2. On the Z13DT engine, the cover is installed on 4 ball-shaped supports fixed to various elements of the engine assembly. The tightness of the fit is ensured by rubber sealing supports. To remove the cover, simply pull it up with sufficient force - the rubber sealing supports should remain on the cover, otherwise remove them manually and install them in the corresponding sockets of the cover.

3. To install, align the mounting sockets with the rubber seals of the top cover with ball-shaped tips and press on the cover until it is fixed on the supports - the cover should fit tightly to the mating surfaces.

4. To remove the cover of the Z14XE/Z16XE/Z18XE engines, first remove the oil filler cap, and on the Z16XE engine, additionally disconnect the cooling system hose. Unscrew the 2 fastening screws, slightly lift the cover by the rear edge, and slide it horizontally forward (to the radiator), then disconnect from the front rubber holders. Install the oil filler cap in place.

5. Install the cover in the reverse order, tighten the screws with the required force.