2. Remove the brake pedal bracket support mounting bolt from the bulkhead (see accompanying illustration). Disconnect the brake light switch sensor wiring connector and remove the switch (see Section 18).
14.2. Bolt (1) securing brake pedal bracket support to bulkhead: 2. Electrical wiring connector; 3. Brake light switch sensor; 4. Wiring harness holder
3. Release the sensor-switch wiring harness from the holder on the brake pedal bracket (see illustration 14.2).
4. Remove the retaining plate and separate the brake pedal return spring (see accompanying illustration).
14.4. Fixing plate (1) of the axle (2) for fastening the master cylinder rod to the brake pedal - the nuts fastening the pedal assembly to the passenger compartment bulkhead are indicated by arrows: 3. Return spring; 4. Nuts securing the brake pedal bracket to the support
5. Loosen the 3 nuts securing the pedal assembly to the passenger compartment bulkhead and remove the brake master cylinder rod mounting axle from the brake pedal (see illustration 14.4).
6. Loosen the 2 nuts securing the brake pedal bracket to the support (see illustration 14.4) and remove the pedal assembly.
7. Installation is carried out in the reverse order of removal.
Visitor comments