Removing
1. Disconnect the battery from the ground.
2. Put the car on the handbrake, raise the front of the car and place it on stands.
3. Drain the engine oil.
4. Disconnect from a collector an exhaust pipe.
5. Disconnect the connector from the oil level sensor in the sump.
Models without air conditioning (stamped steel pallet)
6. Remove the bolts and remove the bottom plate using the gearbox housing and engine (see photo).
7. Gradually and evenly turn away bolts and nuts of the oil pallet. Open the pan seal with palm strokes, lower the pan and remove it from under the car (see photo). Unscrew the two bolts and remove the oil receiver with the coarse filter and the O-ring. Wash the pre-filter in solvent and check for blockages or damage. If there are any signs of damage, replace the oil receiver assembly with filter.
Models with air conditioning (aluminum alloy pallet)
8. Turn away bolts of fastening of a flange of the pallet to a check point case.
9. Gradually and evenly unscrew the bolts securing the pallet to the cylinder block (see photo). Open the pan seal with palm strokes, lower the pan and remove it from under the car. Unscrew the two bolts and remove the oil receiver with the coarse filter and the O-ring. Wash the filter in solvent and check for blockages or damage. If there are any signs of damage, replace the oil receiver assembly with filter.
Installing a non-air-conditioned model (stamped steel pallet)
10. Clean the split planes of the sump and cylinder block from the remnants of the seal, then wipe clean the sump and the internal surfaces of the engine.
11. Place a new O-ring in the oil receiver groove, install the oil receiver and tighten the bolts (see photo).
12. Clean the split planes and apply sealant to the plane of the cylinder block in the places indicated in the photo.
14. Establish the pallet with a new laying, tighten bolts with the set moment.
15. Install the removed parts.
Models with air conditioning (aluminum alloy pallet)
16. Clean the split planes and apply sealant to the plane of the cylinder block at the joints with the oil pump housing and the breathers of the rear main bearing
17. Establish the pallet with a new laying, tighten bolts with the set moment.
18. Install the rest of the removed parts.
Visitor comments