Contents: Removal ⬇ Installation ⬇
Note: Before you begin, see. Chapter 3.
Removal
1. Disconnect the negative cable from the battery.
2. Apply the handbrake, then jack up the front of the vehicle and support it on axle stands placed under the sides of the body frame.
3. On DOHC models, remove the lower engine skid plate as described in Section 11.
4. Note the wiring connections on the traction relay, then disconnect it (see illustration).
5. Where applicable, remove the bolt securing the exhaust bracket and starter mounting bracket to the cylinder block (see illustration).
6. Remove the two starter mounting bolts. Note that the top bolt on some models is bolted to the transmission side and secures the wiring harness bracket (see illustration).
7. Remove the starter.
Installation
8. Install in reverse order, but where necessary check that the wiring harness bracket is in place and tighten all bolts to the specified tightening torque Specifications.
Information taken from the website opelbook.ru
Visitor comments