Contents: Removal ⬇ Installation ⬇
Valeo starter assembly
1 - Spring
2 - Mounting screws
3 - Traction relay
4 — Retaining ring
5 — Thrust ring
6 — Overrunning clutch with gear
7 — Electric motor with planetary gearbox
8 — Insulating sleeve
9 — Housing cover
10 — Nuts for fastening the housing cover
11 — Insulation of the housing cover
12 — Spring
13 — Insulating brush plates
14 — Negative contact brush
15 — Brush holder
16 - Sealing
17 — Positive contact brush
18 — Corps
19 - Screws
20 — Support sleeve
21 — Fork lever pin
22 — Fork lever
The starter is located behind the cylinder block and is removed downwards.
Removal
1. Disconnect the negative cable from the battery.
2. On a diesel engine, engage the manual transmission into gear so that you can reach the starter.
3. Disconnect the wires from terminal 30 (1) and terminal 50 (2) on the traction relay.
Traction relay terminals
4. Remove the mounting bolts (1) from the flange.
Flange mounting bolts
5. Remove the starter.
Installation
1. On petrol engines, install the starter and tighten its mounting bolts with force 25 Nm.
2. On diesel engines, tighten the upper starter mounting bolt to 75 Nm, and the lower one - with effort 45 Nm.
3. Connect the wires to terminals 30 and 50 of the traction relay.
4. Connect the negative cable to the battery.
Connect the wire only with the ignition off to avoid damaging the ECM.
Visitor comments