Caution! The accelerator cable is sensitive to kinks and requires careful handling. A minor kink may cause the cable to break later during operation. Such a cable should not be installed.
Remove the air filter.
Set the throttle valve of the first chamber to the feed position. To do this, start the engine, disconnect the air hose of the starting device and plug the branch pipe with a plug (see arrow in fig.). Turn off the engine.
Pull the starting device pusher back. A gap A is formed between the end of the screw and the pusher (see fig.). Adjust its size if necessary.
(Material copied from this resource: «OpelBook.ru»)
Check if the throttle lever touches the adjusting screw (see arrow in Fig.C4867); adjust if necessary.
Adjust the cable so that its central part can bend freely. The spring should not press on the block.
Remove the plug from the vacuum pipe and connect the hose.
Install the air filter.
Erase the fault codes from the computer's memory by briefly disconnecting the ground wire from the battery.
Visitor comments