Removal and installation the fuel filter (Opel Vectra A)

The fuel filter is replaced during maintenance and every time the carburetor is cleaned.

Removal

Disconnect the fuel supply hose from the carburetor, after loosening the clamp.

Screw the M3 screw into the fuel filter to a depth of approximately 5 mm and remove the filter together with the screw.

Screw the M3 screw into the fuel filter to a depth of approximately 5 mm and remove the filter…

Installation

Insert a new filter.

Connect the fuel hose and secure it with a clamp.

[Text copied from an internet website www.OPELBOOK.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Zinoviev Kirill

Share information:

Opel Vectra A: Fuel system (carburetor)

Checking idle speed and adjusting CO content in exhaust gases
Adjusting the accelerator cable
Removal and installation the carburetor cover
Removal and installation the carburetor
Carburetor calibration data
Carburetor 2EE

Air damper control device
Throttle starting device
Removal and installation the throttle valve starter filter
The device of the carburetor 2E3
Calibration data of the 2E3 carburetor
Removal and installation the 2E3 carburetor

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet