Removal
1. Place the vehicle on a lift.
2. Loosen the parking brake cables using the adjusting nut A of the equalizer (figure 8.7).
Figure 8.7. Loosen the parking brake drive cables using the adjusting nut A of the equalizer.
3. Remove cable B. Disconnect cable C. Unscrew bolts D securing the parking brake lever, remove the parking brake lever (figure 8.8).
Figure 8.8. Remove cable B. Disconnect cable C. Unscrew bolts D securing the parking brake system drive lever, remove the parking brake system drive lever.
Installation
4. Installation is carried out in the reverse order of removal.
Adjustment
5. Tighten and release the parking brake lever five times to return the parking brake cables to their normal operating position.
6. Measure the X dimensions on the left and right brake mechanisms (figure 8.9). The sum of the dimensions should be within 0.1-0.5 mm.
Figure 8.9 Measure the X dimensions on the left and right brake assemblies.
Attention! The sum of the dimensions should not exceed 0.5 mm.
7. Adjust these dimensions using the equalizer adjusting nut.
8. Pull and release the parking brake lever five times to return the parking brake cables to their normal operating position. Check the adjustment.
Tightening torques
Parking brake system drive lever mounting bolt - 44 Nm.
Visitor comments